You can wash wheels as if you were washing with your own hands. The Wheel Mitt helps you wash even the narrowest of spaces on the wheels where a sponge cannot reach. It is designed to prevent water from soaking into your wrist. Can be used for left or right hand.
pH balanced Iron remover/cleaner designed to dissolve brake dust and iron contaminants upon contact.
Directions
1. Wash off sand, mud or dust prior to spraying.
2. Shake bottle well approx. 20 times, and turn trigger "ON".
3. Spray on surface liberally, initially colourless liquid will gradually turn purple/red within approx. 1-4 minutes.
4. Thoroughly rinse treated surface with a strong stream of water. If solution dry on fully, use a stronger jet of water from a pressure washer to remove film.
* When spray over brake disc, it reacts and changes colour.
Rinse away immediately, if left on too long, may cause bad effects for brake disc.
5. Wipe off with clean towel.
Carry out brake test with low gear 2-3 times after cleaning.
* This product is formulated for wheel.
If use for car body, carefully rinse off with water afterwards.
Solid wax creates a hard coating durable up to 1 month. Enhances tire natural gloss black. Can be used to on tires, convertible leather top, fix scuff marks on exterior bumper and trims.
Directions
1. Remove dirt from tires, convertible leather top or bumper in advance.
2. Take cap off and take out included applicator sponge.
3. Put wax on desired area and apply it thinly.
4. Allow to dry for approximately (5-10 minutes), polish with a soft cloth to get ultimate, beautiful matte finish.
Coating agent creates super hydrophobic layer onto wheel surface, prevents brake dust adhesion and keeps beautiful condition for a long time. Nano size lotus leaf coating agent prevents adhering water, brake dust and dramatically repels the dirt. All you have to do is wash the wheels, wipe off water, remove oily component with included wipes, then spray and dry. 8 wheels are available to apply in 1 bottle.
Directions
1. Clean wheels by removing dirt with detergent and dry off water.
2. Use included wipes to decontaminate surface ensure all areas are wiped down.
3. Shake bottle well and spray 10cm away from wheel.
Allow to dry 20min in summer (30℃), 60min in winter (10℃)
Do not drive until it gets dry.
* If, surface gets whiten or liquid streak looks uneven, symptom would disappear after time goes by. (If large amount is sprayed, whiten marks will remain)
* Liquid may accumulate at bottom of tires, in case wipe off with wrung towel before it dries. If liquid adheres to other areas, wipe off immediately.
Quick and easy glossy tire shine!Applicator can adjust for tire shape and easy to apply. Can apply up to 3-4 vehicles. High gloss finish with durability up to 6 weeks!
Directions
1. Wash off sand or dust in advance and ensure tire is dry.
2. Shake bottle well.
3. Remove cap and squeeze bottle allowing liquid to soak sponge.
4. Attach sponge side to tire sidewall and spread evenly around tire.
5. Allow to dry for approximately 5-10 minutes. No need to wipe off.
BLACK BLACK creates a thick-film coating on tires and maximizes shine along with super durability. The non-sticky, hard coating prevents dirt from adhering, which helps your car maintain ideal conditions by simply washing. The coating lasts for more than 60 days, and this rubbing type does not splatter over other parts.
Directions
* Be sure to wear protective gloves. * If the tire is very dirty, remove unwanted residue in advance. * Do not use this product on wet tires.
1. Shake bottle well and put liquid on black side of included sponge. Allow enough liquid to soak thoroughly into applicator sponge.
2. Apply to tire and spread evenly across the tire.
Apply repeatedly until desired level of gloss is achieved.
3. Allow coating to dry for approximately 5-10 minutes after applying.
* If liquid gets into unwanted parts, wipe it off immediately with a clean towel or SOFT99 Silicone Off (sold separately).
Prevents tires and plastic leather from deteriorating, also gives a glossy finish to the surface. Wax brings out the maximum natural shine in the texture of the material. Wiping not necessary when using on tire. When using on leather, wipe off with a cloth after spraying.
Direction
1. If you use tires, wash off mud or dirt in advance.
2. Hold about 15-25cm away from the tire sidewall and spray evenly.
If applying on leather spray and spread thinly with a dry cloth.
Unique mist-mousse spray system accelerates the process of tire dressing, cutting down working time to a quarter that of conventional products. Unwanted residue just melts off and away from the tires, leaving them with a beautifully even shine. Two types of high viscosity silicones adhere to the tires, giving them a glossy, waterproof barrier.
Direction
1. Wash off any excess dirt beforehand if necessary.
2. Shake well and spray onto wet or dry tires.
3. Wait to dry before driving, or wipe away excess liquid with a cloth.
pH balanced Iron remover/cleaner designed to dissolve brake dust and iron contaminants upon contact.
Directions
1. Wash off sand, mud or dust prior to spraying.
2. Spray on surface liberally, initially colourless liquid will gradually turn purple/red within approx. 1-4 minutes.
3. Thoroughly rinse treated surface with a strong stream of water. If solution dry on fully, use a stronger jet of water from a pressure washer to remove film.
* When spray over brake disc, it reacts and changes colour.
Rinse away immediately, if left on too long, may cause bad effects for brake disc.
4. Wipe off with clean towel.
Carry out brake test with low gear 2-3 times after cleaning.
* This product is formulated for wheel.
If use for car body, carefully rinse off with water afterwards.
